Progress in the manufacture of the US-DPC test coil

TitleProgress in the manufacture of the US-DPC test coil
Publication TypeJournal Article
Year of Publication1989
AuthorsHoenig, M. O., M. Takayasu, R. N. Randall, J. E. Tracey, J. R. Hale, M. M. Morra, I. Hwang, and P. Marti
JournalMagnetics, IEEE Transactions on
Volume25
Pagination1738 -1741
Date Publishedmar.
ISSN0018-9464
Keywords2 m, cable manufacture, cable-in-conduit conductor, conduit fabrication, Cr plating, fabrication, JAERI, Japan Atomic Energy Research Institute, manufacture, MIT, Nb3Sn, niobium compounds, superconducting cables, superconducting magnets, superconducting ohmic heating coil, type II superconductors, United States Demonstration Poloidal Coil, US-DPC test coil, wire chrome plating
Abstract

A superconducting ohmic heating coil is being built by MIT to be tested in early 1990 at the Japan Atomic Energy Research Institute (JAERI). This 2-m-diameter coil will be wound from Nb3Sn cable-in-conduit conductor. The coil and conductor are briefly described. Manufacturing procedures and problems encountered in the fabrication of the conductor up to August 1988 are considered. Included are descriptions of wire chrome plating, cable manufacture, and conduit fabrication

URLhttp://dx.doi.org/10.1109/20.92637
DOI10.1109/20.92637

a place of mind, The University of British Columbia

Electrical and Computer Engineering
2332 Main Mall
Vancouver, BC Canada V6T 1Z4
Tel +1.604.822.2872
Fax +1.604.822.5949
Email:

Emergency Procedures | Accessibility | Contact UBC | © Copyright 2021 The University of British Columbia